All site utilities will be provided by others to within five feet of the building line; capped with the location identified and staked. All piping, service, conduit, and connections from that point into the building shall be the responsibility of this subcontractor.
Provide all inserts, hangers, sleeves, supports, brackets, hardware, fasteners, isolators, etc., as required to properly install this work.
Provide all cutting and patching as required to completely install this work.
Seal all penetrations that are created because of the installation of this work.
Notify the Construction Manager in writing within 20 days of the issuance of this contract as to the location of all openings (sleeving, penetrations, etc.) as required for the installation of this work. In the case that this subcontractor fails to request all the required openings in a timely manner, this subcontractor shall become responsible for any charges associated with the completion of this work.
Notify the Construction Manager in writing within 20 days of the issuance of this contract as to all requirements for equipment installations that may require that walls, ceilings, floors, doors, etc. be left out pending these equipment installations.
Provide all caulking, insulation, grouting, and sealants that are related to this work.
Provide all necessary excavation, backfill, compaction, de-watering, sheet piling and shoring as required for this work.
Provide all related signage, tagging and other identification devices related to this scope of work (i.e., labeling of walls, identification of valves and piping, labeling of panels, etc.).
Provide all task lighting necessary to properly install this work. The electrical contractor shall be responsible for providing temporary lighting at the level required by OSHA.
The contractor shall participate in the development of the underground and above-ceiling coordination drawings/meetings. A set of drawings will be provided to this subcontractor and shall be returned to A.D. Morgan within 30 days.
Perform and/or provide all testing as required to certify all systems within this scope of work. A.D. Morgan shall witness all testing.
Material testing shall be provided by others. All costs associated with re-testing of non-conforming work shall be the responsibility of this subcontractor. Notification must be provided to A.D. Morgan 24 hours prior to the test.
A full-time superintendent who is a direct employee of this subcontractor shall always be on-site while this work is in progress. This applies to all situations including that work which might be sub-subcontracted.
Provide daily clean-up of all debris generated because of this work. A dumpster / dump fees will be provided by A.D. Morgan.
Provide all layout and engineering as required for this work. Provide a licensed engineer/surveyor if required.
Provide a full body harness with appropriate fall protection for all personnel when working higher than six feet above ground unless otherwise permitted by OSHA.
Schedule all deliveries with A.D. Morgan at least 24 hours in advance. All deliveries shall be made between 7:30am and 2:30pm unless otherwise agreed to by A.D. Morgan. All deliveries shall be received, unloaded, stored, and protected by this subcontractor in a location as approved by A.D. Morgan.
Provide all hoisting, rigging, staging, and scaffolding as required to perform this work. Any engineering / certification for scaffolding or shoring will be the responsibility of this subcontractor.
This subcontractor shall be required to provide and pay for all required permits.
Provide 100% payment and performance bond for this work. The surety shall be acceptable to the Owner and A.D. Morgan.
Provide two sets of all SDS (Safety Data Sheets) as required by OSHA.
Provide all necessary safety equipment as required by governing regulatory agencies.
As-built documents shall be maintained in the jobsite office trailer. This subcontractor shall be responsible for monthly updates to this set of documents and they are a condition of monthly payments.
This subcontractor shall be responsible for attending both the weekly jobsite safety meetings and subcontractor meetings. This attendance must begin two weeks prior to commencement of this contract work.